Toggler HSA5622 Sleeve-TITE 5/16 x 2-1/2" Hex Nut Sleeve Anchors - 100PC

The Sleeve-TITE™ sleeve anchor is a high-strength pre-assembled expansion anchor designed for anchoring into concrete, masonry, and brick. The Sleeve-TITE anchor has a 6-dimple expansion sleeve over a threaded stud bolt which provides superior performance in all conditions. These anchors are available in a number of head styles for a wide array of applications.

Specifications:
• Diameters: 1/4" – 3/4"
• Carbon Steel Anchor Materials:
• Body:
1/4 through 5/16: C1035
3/8 through 3/4: C1010/ C1018
Expansion Sleeve:
All sizes: C1010/C1018
• Washer:
All sizes: C1010/C1018
Finish: Zinc plating
Meets ASTM B633, SC1 Type III with clear chromate, SC1 class mild
• Stainless Steel Anchor Material:
All components: AISI Type 304
• Federal Specifications:
–QQZ-325C, Type II, Class 3 (clear chromate added)
– GSA FFS-325, Group II, Type 3, Class 3

Applications
• Shelving
• Cable Trays
• Sill Plates
• Door Frames
• Window Frames
• Railing

Installation
1. Drill the hole perpendicular to the work surface. To assure full holding power, do not ream the hole or allow the drill to wobble. Drill the hole at least 1 anchor diameter deeper than the calculated embedment depth, but not closer than two anchor diameters to the bottom surface of the concrete. Through drilling is allowed when using sleeve anchors in hollow concrete block.
2. Clean the hole using compressed air and a nylon brush. A clean hole is necessary for proper performance.
3. Drive anchor through the fixture into the hole making sure the nut, or head, rests solidly against the fixture. Be sure the anchor is set to the required embedment depth.
4. Tighten the nut, or head, 3 to 5 turns past the hand-tight position.